First I removed the two exhaust pipes because they was bad to keep using which why it was going to cut on end of the part so it will be replace to new(only other side)
but my area is brake and I removed cap of back wheel for cheeking the blake which cause the blake part behind on the wheel of cap so I removed that first and then I removed the brake caliper and I carried brake caliper to table and I checked still working and I disassemble the brake caliper for looking at piston, brake pads and rubber cap I could found the problem that problem was the brake caliper piston has a lot of dust so I trying to clear the dust by sandpaper but that had a damage so the pistons will be replace and I also cleared hose with pressure brake fluid,
and brake pads wasn’t useful because they was too old so they will be replace too and the rubber cap also had a dust but it will using again and of course I will cleaning that parts
,so here is I need to do conclusively first I need to get new part(brake pads and brake caliper piston) and second I will do assemble again successfully.
No comments:
Post a Comment